Home Messages Index
[Date Prev][Date Next][Thread Prev][Thread Next]
Author IndexDate IndexThread Index

Re: Tungsten T3 dead

  • Subject: Re: Tungsten T3 dead
  • From: Roy Schestowitz <newsgroups@schestowitz.com>
  • Date: Fri, 15 Jul 2005 16:14:44 +0100
  • Newsgroups: comp.sys.palmtops.pilot
  • Organization: schestowitz.com / Manchester University
  • References: <42d7baf4$0$1716$da0feed9@news.zen.co.uk> <db8g9j$2p37$1@godfrey.mcc.ac.uk> <42d7c5b0$0$24455$db0fefd9@news.zen.co.uk>
  • Reply-to: newsgroups@schestowitz.com
  • User-agent: KNode/0.7.2
antgel wrote:

> Roy Schestowitz wrote:
>> antgel wrote:
>>>My T3 is dead.  Won't even respond to a hard reset.  Green charge light
>>>does come on when it's in the cradle.  Any ideas before I call Palm?
>> If you feel comfortable going along with my suggestion, try draining the
>> battery or removing it, then putting it back in. I don't know if it
>> invalidates the warranty though. I am not sure there is a warranty
>> either. That is probably as farther as you can go at the stage before
>> handing it over to an engineer. If you have no data to lose, you might as
>> well go for the battery.
> But would it not work in the cradle if it was a battery problem?

The reason you need to remove the battery is so that the unit becomes
'clinically dead' for a few seconds. When it gets some power again, its
state will possibly be better. There is nothing to be lost and people
reported this to have resolved their problems in the past. Symptoms were
similar to that of your T3.


Roy S. Schestowitz

[Date Prev][Date Next][Thread Prev][Thread Next]
Author IndexDate IndexThread Index